Design Mistakes to Avoid with Wall Tile Border Trim

Wall tile border trim can be a beautiful and functional addition to any bathroom or kitchen, but it can also be a disaster if not done correctly. Here are some of the most common design mistakes to avoid:

Choosing the Wrong Size Trim

The size of the trim should be proportionate to the size of the tiles and the overall space. A trim that is too thick or too thin will look out of place, and wide borders can visually shrink a smaller room.

Using Too Much Trim

Too much trim can make a space look cluttered and busy. Use trim sparingly, and only where it will add visual interest or highlight a specific area.

Not Matching the Trim to the Tile

The trim should complement the tiles in terms of color, style, and texture. Using a trim that is too different from the tiles can create a disjointed look.

Overlapping the Trim

The trim should be installed so that it overlaps the tiles by just a small amount. Overlapping the trim too much can make it look bulky and unprofessional.

Using the Wrong Adhesive

The type of adhesive used to install the trim will depend on the type of tile and trim. Using the wrong adhesive can cause the trim to come loose or damage the tiles.

Not Sealing the Trim

The trim should be sealed to protect it from moisture and stains. Unsealed trim can become discolored or damaged over time.

Leaving Gaps Between the Trim and Tiles

Gaps between the trim and tiles can create a breeding ground for mold and mildew. Fill any gaps with caulk or grout to prevent moisture from seeping in.

Not Installing the Trim Level

The trim should be installed level so that it does not create a tripping hazard. Use a level to ensure that the trim is installed correctly.

Installing the Trim Too Close to Fixtures

The trim should be installed far enough away from fixtures so that it does not interfere with their operation. Installing the trim too close to fixtures can make it difficult to use them.

Using the Wrong Tools

The wrong tools can damage the tiles or the trim. Use the correct tools for the job, such as a tile saw to cut the trim and a trowel to apply the adhesive.